( 5 ) Fillet wound roll with 1 HP geared Motor Drive.
( 6 ) Inverter Drive control to 1 HP geared Motor.
( 7 ) Tensioning Device
( 8 ) Sheet Metal Structure .
(B) INSPECTION TABLE :
( 1 ) Aluminum guide roll with bearings.
( 2 ) Inspection slant table with Glass/Acrylic top.
( 3 ) Laminar table light behind Glass/Acrylic
( 4 ) Over head table light laminar with angle adjustment.
( 5 ) Operating push button station, start-stop, speed increase-decrease, forward-reverse.
( 6 ) Digital meter counter.
( 7 ) 3Nos. Aluminum Roll with bearings.
( 8 ) 1 No. Fillet wound Roll with 1 HP geared motor Drive.
( 9 ) Inverter drive control to 1 HP geared motor.
( 10 ) Wooden base plat form.
( 11 ) Sheet metal structure.
(C) FABRIC OUTLET DEVICE :
( 1 ) 1 No. Aluminum guide Rolls with bearings.
( 2 ) 2 No. Aluminum Dancing guide Rolls with bearings, guide, chain of sprocket with tension sensing device.
( 3 ) Pair of pneumatic air guider. With pneumatic FRL controls.
( 4 ) 1 No. Aluminum Fabric out let guide roll with bearings.
( 5 ) Sheet metal structure.
(D) SMALL ROLL WINDING ATTACHMENT :
( 1 ) 1 No. Aluminum guide roll with bearings.
( 2 ) 2 Nos. Fillet wound roll connected to 1 HP geared motor by chain and sprocket.
( 3 ) Wooden cutting slit.
( 4 ) 2 Nos. guide roll for small roll resting during cutting.
( 5 ) Fabric selwage guider with 3 roll Pneumatically adjuster guider.
( 6 ) Sheet metal structure.
(E) BIG BATCH WINDING ATTACHMENT :
( 1 ) Batch Arms with Fillet wound roll.
( 2 ) Curved bar rubber Expander. On Arm
( 3 ) Aluminum guide roll on Arm
( 4 ) Pair of pneumatic cylinders for Arm.
( 5 ) Pneumatic FRL control.
( 6 ) 3 HP geared motor Drive to Big Batch.
( 7 ) Inverter driver to 3 HP Geared Motor.
( 8 ) Sheet metal structure.
( F ) ELECTRIC CONROL PANEL FOR ALL ABOVE STATED INVERTER, PUSH BUTTON STATION, CIRCUIT BREACKER, CONTACTORS, CONNECTORS WITH WIRING.
4 Nos. Inverter drive, PLC control, Safety Photo Electric Switch, Start – Stop, Increase – Decrease, Forward – Reverse Push button station. |
